Clarion NZ501E - Map and Guidance Settings; Green Routing Settings

NX501E/NZ501E English 75
• Directional constraints are taken into account the way that opposite direction is
allowed with a low speed.
• A private road is used only if the destination is there.
• Walkways are excluded from routes.
•
:
• Manoeuvre restrictions and directional constraints are taken into account when
planning a route.
• Roads are used only if access for buses is allowed.
• Private roads, resident-only roads and walkways are excluded from routes.
•
:
• Manoeuvre restrictions and directional constraints are taken into account when
planning a route.
• Roads are used only if access for taxis is allowed.
• Private roads, resident-only roads and walkways are excluded from routes.
Route Planning Method types:
Button Description
Gives a quick route if you can travel at or near the speed limit on all
roads. Usually the best selection for fast and normal cars.
Gives a short route to minimise the distance to travel. It can be
practical for slow vehicles. Searching for a short route regardless of
the speed, this route type is rarely practical for normal vehicles.
Gives a quick but fuel efficient route based on the fuel consumption
data given in Green Routing settings (page 75). Travel cost and CO
2
emission calculations are estimations only. They cannot take
elevations, curves and traffic conditions into account.
Results in a route with fewer turns and no difficult manoeuvres. With
this option, you can make Clarion Mobile Map to take, for example,
the motorway instead of a series of smaller roads or streets.
4.3.5 Green routing settings
These settings determine how Green routes will be calculated. They are also used to display
the cost and CO
2
emission of routes.