Clarion UNGO MS5500 Install Manual

Page 12 - MS5500 Installation Manual
Remote Transmitter Layout
Each system comes with 2 Remote Transmitters, pre-programmed to operate in the Ungo
Standard Mode and will Arm and Disarm the system with chirp confirmation using Button 1.
Transmitter Operating Modes
The MS5500 can be configured to work with the remote transmitters in one of three ways, Ungo
Standard Mode (default), Convenience Mode, or Driver Door Priority Mode. To select or change
the transmitter operating mode, see Programming.
For ease of understanding, any references made in this manual to the Remote Transmitter, are
assuming that the Transmitter Operating Mode is set to Ungo Standard Mode, unless otherwise
stated.
Ungo Standard Mode
This mode is the default setting for transmitter operation.
Button 1 Arms and Disarms the system. This Button also locks and unlocks the doors when the
system is in Valet Mode.
Button 2 controls the system’s Auxiliary Function 1.
When the Arm/Disarm Button is pressed together with any other Transmitter Button, the system
will Arm or Disarm silently (without chirp confirmation).
If the system was programmed to arm without chirp, pressing Buttons 1 and 2 together will arm the system with
chirp.
Button 1
Button 2
Mode Button
LED
Remote Transmitters
Mode Sequence
None:Green:Orange:Red:None:...
ARM/DISARM
AUX 1
AUX 2
MODE
green
MODE
none
MODE
orange
not used
not used
not used
not usednot used
MODE
red
BUTTON 1
BUTTON 2
MODE BUTTON
installation_MS5500.qxd 12/6/99 11:59 AM Page 12

Clarion UNGO MS5500 Specifications

General

Brand	Clarion
Model	UNGO MS5500
Category	Car Alarm
Language	English