30
© 2005 directed electronics, inc.
valet
®
mode
You can prevent your security system from automatically arming
and triggering by using Valet
®
Mode. This is very useful when
washing the vehicle or having it serviced. In Valet
®
Mode, the
security system will not arm, even with the remote, but all
convenience functions (door locks, trunk release, etc.) will
continue to work normally.
To enter or exit Valet
®
Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
®
button within 10 seconds.
The status LED will light solidly if you are entering Valet
®
Mode, and it will go out if you are exiting Valet
®
Mode.
To enter or exit Valet
®
Mode using the remote:
Steps 2 through 3 must be quickly and smoothly completed.
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The status LED will light solidly if you are entering Valet
®
Mode, and it will go out if you are exiting Valet
®
Mode.
To Next Page
Loading...
Need help?
General
