34
© 2005 directed electronics, inc.
short-run/turbo
Short run turbo mode keeps the engine running after arriving at
you destination for a programmable period of 1, 3, 5 or 10
minutes. This allows the system’s timer to conveniently cool
down the turbo after you have left the vehicle.
To activate:
1. Park the vehicle and set parking brake.
2. Remove your foot from the brake pedal and leave the
engine running.
3. Press and release the and buttons at the same
time.
4. The lights will flash to indicate the remote start has entered
short run turbo mode.
5. Turn off the key, the engine will keep running.
6. Exit and secure the vehicle.
7. The engine will turn off after the programmed run time.
setting the clock
To set the clock press and hold for five seconds, the trans-
ceiver will chirp twice and the hour selection will start flashing.
Immediately press to advance the hour selection or to
reverse the hour selection. Once the correct hour is displayed
press again and the minute selection will start flashing.
➜
➜
To Next Page
Loading...
Need help?
General
