Clarion VRX8271 - Clock Settings

Setting the clock
Note:
• This [unction is not available when the display is
stored.
1 ) Press the ADJ button 05] to go to the CON¬
FIGURATION display.
2) Slide the Up/Down button lO to ▼ (down) or
A (up) and move the cursor to “CLOCK".
3) Press ► /!! (center) of the ENT button HJ to
go to clock setting mode.
4) S lide the Up/Down button ! 0 ] to < (left), ►
(right), ▲ (up), or ▼ (down) to set a time.
Increments the figure.
Selects the minute
Decrements the figure.
◄ : Selects the hour (the hour becomes blue
and can be changed).
► : Selects the minute (the minute becomes
blue and can be changed).
▲ : The hour or minute increments while the
corresponding figure is blue.
▼ : The hour or minute decrements while
the corresponding figure is blue.
5) After adjusting the time, press ► /» (center)
of the ENT button [Tj to set it.
* Pressing ► /!! (center) of the ENT button Q]
resets the second to zero.
6 ) Pressing the ADJ button 05] returns the mode
to the previous one.
Notes:
• The time is always displayed in radio and CD
changer modes.
• When the clock mode is turned on when the dis¬
play is stored, after a station is tuned in, the fre¬
quency is displayed for several seconds, then the
time will be displayed.
Turning on and off the clock display
Note:
• This function is not available when the display is
stored.
1) Press the ADJ button 05] to go to the CON¬
FIGURATION display.
2) Slide the Up/Down button [T] to ▲ (up) or ▼
(down) to move the cursor to “CLOCK".
3) Each time you slide the Up/Down button i TJ
to ► (right), the clock display turns on and
off.
4) Press the ADJ button 05] to return to the pre¬
vious mode.
15