Clarion VRX8271 - Clarion VRX8271 Installation Guide: Wiring; Wiring Cautions

6. CAUTIONS ON WIRING
1. Be sure to turn the power off before wiring.
2. Be particularly careful where you route the
wires.
Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the
wires.
3. If the fuse should blow, check to see if the
wiring is correct.
If it is, replace the fuse with a new one with
the same amperage rating as the original.
4. To replace the fuse, release the catch on the
source unit side, remove the old fuse and
insert the new one. (Figure 11)
Note: There are various types of fuse holder.
Do not let the battery side and touch
other metal parts.
Example 1: Amplifier control (Blue/white)
Antenna
Figure 11
5. W hen connecting the ground lead, fasten the
ground lead (black) securely to a clean metal
plate on the car. (Figure 12)
If the set is insufficiently grounded, it may not
operate or there may be noise.
After the connection, fix the lead by a clamp or insulation tape for protection.
A WARNING
This product must be installed and used only in accordance with these instructions. DO NOT
CONNECT A TELEVISION TUNER TO THIS PRODUCT OR OTHERWISE ALTER THIS PRODUCT
SO THAT IT CAN BE USED FOR RECEIVING TELEVISION BROADCAST SIGNALS OR FOR
PLAYING VIDEO TAPES OR VIDEO GAMES. Any alteration of this product that enables it to be
used in ways other than those provided for in this manual could distract the driver and result in
an accident for which the installer may be held liable. CLARION DISCLAIMS ANY LIABILITY
THAT MAY RESULT FROM A FAILURE TO INSTALL AS INDICATED IN THESE INSTRUCTIONS.
42