Clarion VRX8271 - Clarion VRX8271 DSP and Equalizer Operation; DSP Sound Settings

Operating the DSP and Equalizer
Notes:
• To use the functions described in this section, the
DSP (Digital Sound Processor) DPH9100 or
DPH7100, sold separately; or the EQ (Equalizer)
EQH5100 must be connected to the source unit.
Also, some functions are restricted to certain con¬
nection units. Therefore, the model numbers of
the units which incorporate each function are indi¬
cated in the instructions hereafter.
• The functions described in this section are not
available when the display is set.
• When the DPH9100. DPH7100, or EQH5100 is
connected to the source unit, the tone cannot be
adjusted as in the regular mode.
The DSP and EQ can;
• Adjust the listening position (when the DPH9100
or DPH7100 is connected).
• Set the sound setting (when the DPH9100 or
DPH7100 is connected).
• Adjust the sound range (when the DPH9100,
DPH7100, or DQH5100 is connected).
• Enter titles (when the DPH9100 is connected).
Adjusting the listening position
By adjusting the sound propagation time based
on seat position, a natural sound setting can be
created.
Notes:
• This function is available only when the
DPH9100/DPH7100, sold separately, is connected.
• If the control is idle for about 5 seconds after each
operation, the unit returns to the previous mode.
1) Press the AM button [3j to change the dis¬
play to the listening position adjustment
mode.
2) Slide the Up/Down button Q] to ▼ (down) or
▲ (up) to select the listening position.
* Each time you slide the Up/Down button Q],
the adjustment position changes as follows:
The selected position is displayed in white.
FULL SEAT : Center of the cabin space
FRONT-R : Right side of the front seats
FRONT-L : Left side of the front seats
FRONT : Center of the front seats
REAR : Center of the rear seat
POSITION PASS : Usual adjustment
3) Press ► /» (center) of the ENT button jT] to
select the balance adjustment mode.
4) Slide the Up/Down button |Tj to A (up), ▼
(down), -4 (left), or ► (right) to adjust the
balance.
5) Press ► /!! (center) of the ENT button Q] to
enter the adjustment or wait for about 5 sec¬
onds.
The display returns to the listening position
adjustment mode.
Changing the DSP characteristics
The DSP creates the surround effect in the cabin
space without deteriorating sound quality
through digital signal processing.
Selecting the sound setting menu
The sound setting menu can be selected from
the provided DSP menu or from the DSP char¬
acteristics selected by yourself.
Notes:
• This function is available only when the
DPH9100/DPH7100 is connected.
• If the control is idle for about 5 seconds after each
operation, the unit returns to the previous mode.
1) Press the DSP button [jH to select the DSP
mode.
2) Press the BAND button [2 to select DSP
BASIC or DSP USER.
*When the DPH7100 is connected, only the DSP
BASIC menu (same as the DSP BASIC1 for the
DPH9100) is displayed.
*Each time you press the BAND button g], the
DSP menu changes in the following order:
- DSP BASIC1 DSP BASIC2
DSP BASIC1,2: Each menu consists of 6 char¬
acteristics initially set.
DSP USER : This menu is an adjustment
menu to be set by the user (for
setting the menu, see the next
subsection “Setting your own
DSP characteristics").
26