Clarion VRX8271 - Station Memory and Recall

Preset scanning
Note:
• This function is not available when the display is
stored.
1 ) Press the BAND button g] to select a band.
2) Press the DISP button Qoj to select PS/AS
mode.
* Press the DISP button 0oi to return to preset
mode.
3) In PS/AS mode, when No.1 of the Preset but¬
tons gj is pressed, the preset stations are
tuned in for 5 seconds each.
* l~Fs~] in the display becomes pink.
* When a preset station has been tuned in, preset
scanning starts from the station after the current
one. When a preset station has not been tuned
in, preset scanning starts from preset No. 1.
4) When a desirable station is tuned in, press
No. 1 of the Preset buttons [?J to cancel
PS/AS mode and press the preset button to
which the station is to be stored.
*The preset scanning is canceled and you can
listen to the station.
Preset selection
1) Press the BAND button ® to select a band.
2) Press one of the Preset buttons E to select
the stored station.
Note:
• In PS/AS mode, do not perform the preset selec¬
tion (excluding the preset scanning).
In PS/AS mode, when No. 2 of the Preset buttons
[9] is pressed, the auto storing starts and all the
stored stations are cleared.
ISR memory
If an AM or FM station is stored in the ISR but¬
ton, it can be directly tuned in by pressing the
ISR button from any other mode.
1) Press the BAND button GO to select a band.
2) Press the Preset button [9j or the ENT button
Q] to tune in to a station you want to store.
3) Press and hold the ISR button g] for about 2
seconds.
When a beep sounds, the display turns to the
ISR (Instant Station Recall) display and the
frequency is stored.
4) P ress the ISR button [6] to return to the pre¬
vious mode.
INSTANT STATION Rtmi- ...
FM
87.9
Calling the station with the ISR button
1) In any mode, pressing the ISR button _6:
allows you to tune in to the stored station.
*When the ISR is functioning, the ISR display
appears.
*The default ISR setting is 87.9 MHz.
2) To cancel the ISR function, press the ISR but¬
ton [6j or FUNC button [7]. The ISR function
is canceled and the previous mode returns.
Area change
When you listen to the radio outside the U.S.,
use this function.
Switchable frequency setting
This car stereo is initially set to tune in frequen¬
cy intervals of 10 kHz for AM and 200 kHz for
FM, the standard calibrations in the U.S. When
using the unit outside the U.S., use the following
procedure to switch the frequency range.
The table below lists the frequency specifica¬
tions for the U.S. and other countries.
Initial Setting
(U.S. standard)
New Setting
(outside U.S.)
Frequency
spacing
10 kHz
9 kHz
AM
Frequency
range
530 to 1710 kHz 531 to 1629 kHz
Frequency
spacing
200 kHz
50 kHz
rM
Frequency
range
87.9 to 107.9 MHz
87.5 to 108 MHz
17