Clarion VRX8271 - Page 21

Adjusting the brightness and tone
of color
Notes:
• This function is not available unless you stop the
car and apply the parking brake.
• This function is not available when the display is
stored.
• The brightness can be adjusted only when the pic¬
ture of the rear vision camera is displayed.
1) Press the ADJ button SH to select the CON¬
FIGURATION display.
2) Slide the Up/Down button UJ to ▼ (down) or
▲ (up) to move the cursor to “DISPLAY".
• r'nMCrtaHra/v'nnf.i
;T?p--i.iii , jH,.iirn j iTtni'f
PKj;r,r 1
1 PUSH ENT ■ CLOCK I
WM ffl
1
■ jjH,
T
Adjusting the brightness
3) S lide the Up/Down button Q] to ► (right) to
select either of BRIGHT, COLOR, or HUE.
Each time you slide the Up/Down button Lll
to ► (right), the adjustment mode switch¬
es in the following order:
d
BRIGHT - COLOR
-HUE
Z)
BRIGHT :Adjusts the brightness of the dis¬
play.
COLOR :Adjusts the color saturation.
HUE :Adjusts the tone of color, (red is
emphasized <-» green is empha¬
sized.)
4) P ress ► /!! (center) of the ENT button Q] to
select what to adjust.
— BRIGHT
Darken. Brighten.
BRIGHT is selected.
5) S lide the Up/Down button [T| to ► (right) or
4 (left) to adjust the brightness.
6 ) After the adjustment, press ► /» (center) of
the ENT button [Tj to return to the CONFIG¬
URATION display.
7) Press the ADJ button jl5] to return to the pre¬
vious mode.
22