4.4
Functional Checks
Check the operation of the truck as follows:
NOTICE
Before performing these checks, familiarize yourself
with the operating procedures in Section 5.
1. Test warning devices, horn, and other safety equipment and
accessories.
2. With the key switch ON, check the electronic display. The elec-
tronic display should show the charge remaining on the battery,
the hour meter or a fault code.
3. Be sure all controls and systems operate freely and return to
neutral properly. Check the:
• Brake system
• Hydraulic controls
• Control handle (Direction/Accelerator and Steering control)
• Steering system
When the functional checks are completed:
1. Bring truck to complete stop.
2. Lower the lift mechanism fully.
3. Raise handle to the full "up" position (Brake will automatically
apply when the handle is raised).
4. Remove the key (OFF position).
If you are going to leave the truck unattended:
5. Remove the key (OFF position)..
6. Block the wheels, if the truck has the possibility of moving.
7. Press the Emergency Shut O Switch.
Operator Maintenance and Care
To Next Page
Loading...
