5.6
Operating Procedures
• Lower forks completely before
entering load.
• Center forks with load as you
approach.
• Enter load as far as possible.
• Make sure the lifting area is
clear before lifting load.
• Raise forks enough to elevate
the load before moving truck.
• Avoid operating hazards and
observe general safety rules
while moving.
• Always approach load deposit
areas squarely and cautiously.
• Be especially careful when
placing loads near water pipes,
electrical wiring or outlets,
steam pipes, heaters, and other
dangerous or fragile equipment.
• After placing load in position,
lower the forks completely.
• Withdraw the forks squarely
from the load.
Load Handling
To Next Page
Loading...
