Clarke 07163A - Troubleshooting

EN
ENGLISH
Clarke
®
American Sanders Operator's Manual (EN) - EZ Sand - HDTR FORM NO 71358A - 9 -
Troubleshooting
Problem Cause Action
Motor will not start. No power. Check power supply and connection
Interlock not depressed. Depress Interlock before activating control lever
Defective switch/ Bad connection Contact an authorized American Sanders Technology
Dealer.
Motor fails to start / runs sluggish. Low voltage from excessive length or
undersized extension cord.
Use a 14 Ga extension cord, not to exceed 50’ length.
Defective start switch. Contact an authorized American Sanders Technology
Dealer.
Defective motor low voltage Contact an authorized American Sanders Technology
Dealer.
Fuse / Circuit Breaker repeatedly
trips.
Low voltage. Eliminate extension cord.
Locate power source closer to work site. Have voltage
checked by a qualifed electrician.
Bad connection. Contact an authorized American Sanders Technology
Dealer.
Defective motor. Contact an authorized American Sanders Technology
Dealer.
Handle feels loosely connected to
base machine.
The latches have loosened up. To tighten latches, loosen the lock nut, screw in the latch
hook and then tighten the lock nut.