11
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
GENERAL OPERATION
If the room is exposed to direct sunlight, draw any curtains during the sunniest
part of the day.
NOTE: Always drain any water from the unit via the drain plug after
operating in DRY mode. The unit will automatically stop working
when water reaches the high level.
NOTE: Do not use the air exhaust duct when in DRY or FAN modes.
1. Plug the unit into the power supply and the unit will enter ‘Standby’ mode
and the LED will display the room temperature.
2. Press the POWER button.
• The unit will start up in COOLING mode using High fan speed.
3. Press the MODE button and select from COOLING, DRYING or FAN only
modes and the corresponding LED will illuminate.
COOLING MODE
1. With the unit running, press the MODE button & choose COOLING mode.
2. Press the UP/DOWN button to set the desired room temperature.
POWER Turns the unit on or off.
TIMER Sets the timer On/Off and allows the running time
duration to be adjusted using the Up/Down arrows.
HIGH Sets the unit to operate at the high fan speed.
LOW Sets the unit to operate at low fan speed.
SLEEP Sets the unit to operate in the sleep mode with the
fan at its lowest setting.
UP or DOWN (arrows) Sets the target temperature or adjusts the run time
duration in TIMER mode.
o
C/
o
F
Switches the display between degrees Celsius to
degrees Fahrenheit.
COOL
DRY
FAN
Selects either: COOLING mode
DEHUMIDIFYING mode
FAN mode
These options correspond to the “MODE” option
on the main control panel.
To Next Page
Loading...
Need help?
General
