6
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
CONTENTS
Ensure the air conditioner and its components suffered no damage during
transit and that all components are present. Should any loss or damage be
apparent, please contact your CLARKE dealer immediately.
The following components are supplied with the unit;
1. Flexible exhaust duct.
2. Exhaust duct outlet connector (2 pieces)
3. Exhaust duct round connector.
4. Adjustable window slider plate.
5. Remote control handset with batteries.
INSTALLATION
IMPORTANT: Do not position your air conditioner where it will be exposed to
sources of heat above 35
o
C.
1. Always transport the air conditioner upright. Remember to drain the tank
before moving the appliance.
• It is recommended to wait up to 2 hours after transporting/unpacking the
air conditioner before using it, to allow the refrigerant gasses to settle.
2. Position the unit on a level, dry surface with at least 50 cm of free air space
around the unit.
NOTE: Do not use the air exhaust duct when in DRY or FAN only modes.
3. Twist fit the round adaptor to the
exhaust duct.
4. Clip the two halves of the duct
outlet connector together before
twist-fitting them to the duct as
shown.
To Next Page
Loading...
Need help?
General
