16
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
STARTING UNDER NORMAL CONDITIONS
1. Take all necessary precautions previously stated, and ensure the
workpiece can rotate fully without obstruction.
2. Set the Speed Range control lever to HIGH or LOW as required.
3. Set the Forward/O/Reverse (F/O/R) switch (C), on the main control panel,
to the O (OFF) position.
4. Engage or ensure the Auto Feed lever is dis-engaged depending upon
whether or not automatic feed is required.
IMPORTANT: This should ALWAYS be a deliberate, conscious action.
NOTE: If Auto feed is required, the Leadscrew Forward/Neutral/Reverse Lever
should be set to FORWARD. If Auto feed is not required the lever may be
set to Neutral. To do this, grasp the knurled handle and pull out against
spring pressure. Holding the handle in this position, move the lever until
the point on its end, locates in the middle pit mark in the casing.
5. Proceed to start the machine as described previously.
6. To stop the machine, turn the Variable Speed Control knob (A) to the 0
RPM position and the F/O/R switch (C) to O (OFF).
CAUTION: ALWAYS TURN THE VARIABLE SPEED CONTROL KNOB TO 0 RPM
AND THE FORWARD/OFF/REVERSE SWITCH TO O (OFF) BEFORE
ATTEMPTING TO CHANGE ANY SETTINGS OR MAKE ANY ADJUSTMENTS.
THIS INCLUDES CHANGING FROM HIGH TO LOW OR LOW TO HIGH
RANGE.
To Next Page
Loading...
Need help?
General
