6
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
2. Do not use the power tool if the switch does not turn it on and off. Any
power tool that cannot be controlled with the switch is dangerous and
must be repaired.
3. Disconnect the power tool from the power supply before making any
adjustments, changing accessories, or storing the tool. These measures will
reduce the risk of the power tool starting accidently.
4. Store power tools out of the reach of children and do not allow persons
unfamiliar with these instructions to operate the power tool. Power tools are
potentially dangerous in the hands of untrained users.
5. Maintain tools in top condition. Keep tools/ machines clean for the best
and safest performance. Check for misalignment or binding of moving
parts, broken parts, or any condition that may affect the power tool’s
operation. If damaged, have the power tool repaired before use. Many
accidents are caused by poorly maintained power tools.
6. Use recommended accessories. The use of improper accessories could be
hazardous.
7. Check the power tool for damage before using the machine. Any
damaged part should be inspected to ensure that it will operate properly
and perform its intended function. Check for alignment of moving parts,
breakage of parts, mountings, and any other condition that may affect the
machine’s operation. Any damage should be properly repaired or the part
replaced. If in doubt, DO NOT use the machine. Consult your local dealer.
SERVICING
1. When necessary, have your power tools serviced or repaired by a qualified
person using identical replacement parts. This will ensure that the safety of
the power tool is maintained.
ADDITIONAL PRECAUTIONS FOR LATHES
1. You should not operate this machine unless you are thoroughly familiar with
metal turning lathes and turning techniques. If there is any doubt
whatsoever, you should consult a qualified person.
2. NEVER attempt to turn a workpiece unless a suitable support is used.
ALWAYS stop the lathe before removing workpieces, work supports or swarf
from the table.
3. ALWAYS be sure that the workpiece is securely locked in position.
4. ALWAYS keep hands and fingers away from the moving workpiece.
5. Ensure all chuck keys, spanners and wrenches are removed from the lathe.
6. Examine the setup carefully, ensuring that nothing could possibly interfere
with the rotating workpiece.
To Next Page
Loading...
Need help?
General
