9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
UNPACKING
Any damage or deficiency should be reported to your CLARKE dealer
immediately.
The components include the following:
• 1 x Gasless MIG Welder (torch and earth clamp attached)
• 2 x 0.9 mm Torch Tips (one installed in the torch)
• 1 x Spool Of Flux Cored Wire
• 1 x Combination Wire Brush / Hammer
• 1 x Split Welding Mask
• 1 x Instruction Manual
OPENING THE COVER
IMPORTANT: Ensure that the welder is not connected to the mains supply.
1. Open the cover, by sliding the top
back ,and then lift the cover open
as shown.
2. Remove any loose items that
have been transported inside.
WARNING: NEVER OPERATE THIS MACHINE WITH THE COVER OPENED
To Next Page
Loading...
Need help?
General
