14
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MAINTENANCE
The welder should be kept clear of any accumulation of dust which could
block the air ventilation louvres and prevent proper cooling. If working in a
dusty atmosphere, brush any dust downwards or use compressed air to
remove dust.
Always inspect both cables before use to ensure they are in perfect condition
and that the earth clamp is clean and secured correctly to the cable.
Consult your CLARKE dealer for any internal repairs if necessary.
STORAGE
1. Turn off the welder and disconnect it from the power supply.
2. Remove and coil the earth cable and electrode /cables and store them
carefully.
Cover the unit and store in a dry location.
DUTY CYCLE
This welder is covered by regulations BS-EN60974-1(2012) and BS-EN 60974-10
(2014), where the Duty Cycle is expressed as a percentage of time the
machine may be used in a given period, for a specified welding current.
e.g. When welding at 80 Amps the machine may be used for 2 minutes (20%)
in any10 minute period, or the machine may be used continuously, (100%)
when welding at 36 Amps or less.
WARNING: ELECTRICITY CAN KILL - NEVER TOUCH LIVE ELECTRICAL
COMPONENTS.
WARNING: DISCONNECT THE POWER SUPPLY BEFORE ALL INSPECTION
AND MAINTENANCE OPERATION BEWARE HOT SURFACES.
WARNING: ALWAYS LET THE POWER SUPPLY COOL DOWN BEFORE
ACCESSING INTERNAL COMPONENTS.