14
DC POWER
For charging car batteries only.
1. Start the engine. See page 11.
2.
Connect the battery charging
leads to the battery.
• Clamp the red wire to the
positive (+) ter
minal and the
black wire to the negative (-)
terminal of the battery. Do not
reverse these positions.
3. Connect the battery charging
leads
to the generator.
DC OVER LOAD PROTECTOR
If the DC overload protector
activates, wait for a few minutes and
then press the reset button shown on
the right.
CAUTION: MAKE CONNECTIONS TO THE BATTERY AFTER STARTING THE
ENGINE.
WARNING: TO PREVENT THE POSSIBILITY OF CREATING A SPARK NEAR THE
BATTERY, DISCONNECT THE CABLE TO THE GENERATOR FIRST AND THEN
DISCONNECT THE BATTERY
WARNING: AFTER YOU HAVE CHARGED THE BATTERY, ALWAYS
DISCONNECT THE NEGATIVE LEAD FIRST.
To Next Page
Loading...
Need help?
General
