9
CHECKING THE ENGINE OIL LEVEL
1. Turn the oil filler cap anti-
clockwise and remove from the oil
tank, wipe the dipstick with a
clean cloth.
2. Insert the dipstick back into the oil
filler tube and then remove it
again. Do not screw in the oil filler
cap/dipstick when doing this.
3.
If the oil is below the ‘L’ level on
the dipstick, fill the oil reservoir to
the ‘H’ level on the dipstick.
• Oil Capacity (See
“Specif
ications” on page 21.)
• We recommend the use of
SAE30 oil in this generator.
4. Replace the oil filler cap.
WARNING: TO CARRY OUT THIS CHECK, PLACE THE GENERATOR ON LEVEL
GROUND WITH THE ENGINE SWITCHED OFF (O).
WARNING: TAKE CARE NOT TO TOUCH ANY HOT PARTS OF THE
GENERATOR WHEN CHECKING THE OIL LEVEL.
To Next Page
Loading...
Need help?
General
