EasyManuals Logo

Clarke Power FG3000 User Manual

Clarke Power FG3000
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
UNPACKING AND ASSEMBLY
Unpack your generator and check to ensure the following items are present.
Should there be any deficiency or damage caused during transit contact
your Clarke dealer immediately.
•The Generator
Spark Plug Box Spanner
•Tommy Bar
12 Volt DC Battery Charging Lead
BEFORE USING THE GENERATOR
IMPORTANT: Generators should ALWAYS be earthed.
Attach a suitable earth lead to a good earth - water pipe, ground spike etc.,
whenever you use this generator.
Before using your generator check that:
The generator is in good condition and free from any damage.
The generator is clean and free from fuel or oil spillage.
The generator is correctly located for use (See page 4).
The fuel system and connectors are intact and there is no leakage.
NOTE: Always use a funnel to fill the fuel tank so as to avoid accidental
spillage of fuel. If fuel is spilled it must be removed from the unit
before attempting to start the engine.
EARTH POINT
Always connect the generator to an
earth point. The earth terminal is
shown on the right.
WARNING: ENSURE THERE IS ADEQUATE FUEL IN THE TANK WHEN USING
THE GENERATOR. RUNNING OUT OF FUEL OR STOPPING THE ENGINE
SUDDENLY WITH A LOAD CONNECTED COULD CAUSE SERIOUS DAMAGE.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clarke Power FG3000 and is the answer not in the manual?

Clarke Power FG3000 Specifications

General IconGeneral
BrandClarke
ModelPower FG3000
CategoryPortable Generator
LanguageEnglish

Related product manuals