19
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MAINTENANCE
CLEANING THE NOZZLE
1. Switch off the pressure washer and the water supply.
2. Pull the trigger to release any water pressure.
3. Disconnect the lance from the gun assembly.
4. Remove all blockages with the
nozzle cleaning tool provided and
back flush with clean water.
5. Run water into the end of the
lance for 30 seconds to back flush
loose particles.
6. Reconnect the lance to the gun
assembly and turn on the water.
CLEANING THE WATER INLET FILTER
1. Remove the filter from the water
inlet of the pump as shown.
2. Clean the filter by flushing both
sides with water.
3. Replace the filter into the water
inlet.
• Do not operate without the
filter properly installed.
CLEANING THE FUEL STRAINER
Just inside the fuel tank is a fuel strainer, check this periodically and remove
any contaminants which may have accumulated.
1. Open the fuel tank cap.
To Next Page
Loading...
Need help?
General
