6
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
UNPACKING AND ASSEMBLY
Unpack your pressure washer and make sure that the following items are
present. Contact your CLARKE dealer immediately if any parts are missing or
damaged.
CONNECTING THE WHEELS
1. Slide the axles into the locating
tube as shown.
• Make sure the ball catch locks
into the small hole on the
bottom of the locating tube.
2. Add the 2 axle covers as shown.
• 1 x Petrol Power Washer • 1 x Gun Assembly
• 2 x Wheel c/w Axle • 1 x Lance / Nozzle Assembly
• 1 x Upper Handle c/w fixings • 1 x Spark Plug Box Spanner
• 1 x Hose Bracket c/w fixings • 1 x Tommy bar
• 1 x Lance Bracket c/w fixings • 1 x Engine Manual
• 1 x Primer Bottle • 1 x Primer Bottle Holder
• 1 x Primer Bottle Bracket • 2 x Rubber feet and fixings
• 1 x Hose • 1 x 3m Inlet water hose
• 1 x Water Filter (may be
supplied already fitted)
To Next Page
Loading...
Need help?
General
