EasyManuals Logo

Clarke Tiger 2600B User Manual

Clarke Tiger 2600B
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
21
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
4. Check the overall condition of the
spark plug and replace if
necessary.
5. Check the spark plug gap (a), it
should be between 0.7 and 0.8
mm, adjust if necessary.
6. Reinstall the spark plug and refit
the spark plug cap.
LONG TERM STORAGE
For long term storage;
1. The petrol tank should be drained.
Ensure that the engine is cold before draining the tank.
2. Remove the fuel tank cap and use a pump type sIphon to drain the petrol
into an appropriate, clean container.
Do not store petrol for long periods of time.
Dispose of excess petrol in an environmentally safe way. Your local
recycling centre can advise you on the best method of disposal.
3. After the petrol tank has been drained, start the engine and allow it to use
any petrol that may remain in the engine, or fuel pipe.
4. Make sure that the power washer has been thoroughly cleaned before
storing it in a clean dry place.
ACCESSORIES
The range of accessories listed below may be purchased from your CLARKE
dealer.
ITEM PART NUMBER
5 Litres Detergent (Traffic Film Remover) 3050821
25 Litres Detergent (Traffic Film Remover) 3050820
5 Litres Wash ‘n’ Wax 3050815

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clarke Tiger 2600B and is the answer not in the manual?

Clarke Tiger 2600B Specifications

General IconGeneral
BrandClarke
ModelTiger 2600B
CategoryPressure Washer
LanguageEnglish

Related product manuals