CLAUSING MS1318M - Adjusting Wire Brush; Test-Running the Machine

To Next Page

To Previous Page

4-14

ADJUSTING WIRE BRUSH

Follow these steps to adjust wire brush to appropriate position:

Step 1 – Open the drive wheel cover. Loosen the adjustment bolt.

Step 2 – Adjust brush to make it move up / down until it makes proper contact with the saw blade

(see below illustration).

Step 3 – Tighten the adjustment bolt. Close the drive wheel cover.

Proper

Improper

TEST-RUNNING THE MACHINE

Test-running this machine can ensure good machine performance in the future. We suggest you run

the following tests on the machine before first use:

Testing machine performance:

Turn on the power and run a basic performance test after you finish installing the machine. Follow

these steps to test machine performance:

Step 1 – Disassemble shipping brackets and bolts.

Step 2 – Install roller table (standard for MS1318SA).

Step 3 – Turn on the relay switch in the control box.

Step 4 – Elevate the saw bow. (If your coolant pump is in reverse and the machine cannot run, please

change the electrical phase.)

Step 5 – Remove the rust-prevention grease with cleaning oil or kerosene.

Step 6 – Start the coolant pump.

Step 7 – Test these functions:

vise clamping/unclamping

saw bow ascending/descending

MS1318M / MS1318SA