CLAUSING MS1318M - Page 74

7-2!
INTRODUCTION
1.

73,
7KHQXPEHURIWHHWKSHULQFKDV PHDVXUHGIURPJXOOHWWRJXOOHW
7RRWK5DNH$QJOH
7KHDQJOHRIWKHWRRWKIDFHPHDVXUHGZLWKUHVSHFWWRDOLQHSHUSHQGLFXODUWRWKHFXWWLQJ
 GLUHFWLRQRIWKHVDZ
7RRWK3LWFK
7RRWKSLWFKUHIHUVWRWKHQXPEHURIWHHWKSHULQFKWSLLQFKHTXDWHVWRPP

$GLVWLQFWLRQLVPDGHEHWZHHQFRQVWDQWWRRWKSLWFKHVZLWKDXQLIRUPWRRWKGLVWDQFHWSLIRUH[DPSOHDQG
YDULDEOHWRRWKSLWFKHVZLWKGLIIHUHQWWRRWKGLVWDQFHVZLWKLQRQHWRRWKLQJLQWHUYDO

9DULDEOHWRRWKSLWFKHVIRULQVWDQFHWSLFDQEHFKDUDFWHUL]HGE\WZRPHDVXUHVWSLVWDQGVIRUWKHPD[LPXP
WRRWKGLVWDQFHDQGWSLVWDQGVIRUWKHPLQLPXPWRRWKGLVWDQFHLQWKHWRRWKLQJLQWHUYDO
Constant Variable
Min. Max
6HW
7KHEHQGLQJRIWHHWKWRULJKWRUOHIWWRDOORZFOHDUDQFHRIWKHEDFNRIWKHEODGHWKURXJKWKHFXW
:LGWK
7KHQRPLQDOGLPHQVLRQRIDVDZEODGHDVPHDVXUHGIURPWKHWLSRIWKHWRRWKWRWKHEDFNRIWKHEDQG
7KLFNQHVV
7KHGLPHQVLRQIURPVLGHWRVLGHRQWKHEODGH
*XOOHW
7KHFXUYHGDUHDDWWKHEDVHRIWKHWRRWK7KHWRRWKWLSWRWKHERWWRPRIWKHJXOOHWLVWKHJXOOHWGHSWK
SAW BLADE SELECTION
1. Band length
The dimensions of the band will depend on the band saw machine that has been installed.
!
Please refer to Section 2 – General Information
2. Band width
Band width: the wider the band saw blade, the more stability it will have.
3. Cutting edge material
The machinability of the material to be cut determines what cutting material you should choose.
 7
MS1318M / MS1318SA