Clayton LPS - Use of Starter Help (Extra)

Lithium Power Supply User Manual
!
Page 17
!
!
!
6.7. Use of starter help (extra)
Figure 11
Connect plus to both 12VDC out and in. From there the starter battery and 12VDC load(s) is connected
according to figure 12. The blue and black wire must be connected to pin 6 in the DB9 communication plug
as seen in figure 13.
Note: The fuse, CDR and DB9 communication connector can be purchased at your local Clayton Power
sales representative.
!!
"!!!!!!!!!!!!!!!!!!!!!!!!!!
12VDC!
Load!
+!
+"
#"
CDR!
*!
*12VDC, 100Ah fuse!
Figure 12