12
Product Operation
Cleaning mode
1. Auto cleaning
The robot will clean a room automatically and adjust its cleaning
Mode according to the environment.
Note:
*Press ON/OFF button on remote controller or CLEAN
Button on robot to start auto cleaning.
2. Spot cleaning
Press SPOT on the remote controller to start spot cleaning.
Mote:
*It is suggested that users should select spot cleaning mode only
robot Cleans around the areas with much dust/dirt. After robot
finished cleaning For the dirtier area, it will automatically stop spot
cleaning mode and turn to auto cleaning mode.
3. Edge cleaning mode
Switch on the robot, press MODE on the remote control and select edge cleaning. Under edge cleaning
Mode, the robot will do cleaning along the obstacle by its side brushes.
13
Product Operation
1. Zig –Zag cleaning mode
Robot will automatically goes into Zig-Zag cleaning when it detected it’s in an open area or the
environment with less obstacles.
Note:
C. After switch on the robot, by press MODE on the remote
Controller, user can select edge cleaning. And user can
Also press ON/OFF button to stop it.
D. Mode1 for spiral cleaning, Mode 2 for random cleaning
Mode 3 for edge cleaning, Mode 4 for Zig- Zag cleaning
To Next Page
Loading...
