Cleanmate S 600 - Troubleshooting; Common Problems and Solutions

16
Troubleshooting
Note: if all solutions given above don’t work for you, please take actions below:
1) Re-set the robot by switching on the power button on the control panel.
2) If re-set action doesn’t work, please send the robot to seller for repairing.
Problem
Possible Cause
Solution
1
Robot suddenly stop
cleaning and indicator
keeps in blue
1. Robot was picked up 1. Re-place the robot on the floor and re-start the robot
2
Power on robot, its
indicator keeps in blue
1. Cliff sensor fault
1. Clean cliff senor
2. If solutions given above don’t work out, send it to the
seller for repairing
3
Robot does not change
direction when it comes
up against obstacle
1. Bumper sensor fault
1.Check the sensor to see if it is covered by foreign
object
4
During charging, LED
indicator flashes in red
and robot beeps
1. Robot switch might not
powered on
1. Switch on the robot
5
Red LED stays on
1. Dust bin full
2. Dust passage get
stuck
1. Empty dust bin
2. Clean dust passage
6
LED indicator flashes in
red
1. Battery low 1. Fully charge the battery
7
Blue LED flashes once,
Red LED flashes once.
1. Side brush get stuck 1. Put robot on flat surface and clean side brush
8
Blue LED flashes once,
Red LED flashes twice.
1. Robot bumper not so
flexible
1. Loosen half circle of bumper bottom screw
9
Blue LED flashes once,
Red LED flashes triple.
1. Robot wheel get stuck
1. Check wheels and take out the foreign object
17
Exploded diagram
Below are exploded parts:
18