3
2. Foreword
Read all instructions and warnings before using this device. Keep these user instructions for reference. If you have
questions regarding this system contact CleanSpace Customer Service on +612 8436 4000 or e-mail
support@cleanspacetechnology.com.
3. System Description
CleanSpace HALO is an EN12942 and AS/NZS 1716 compliant respiratory system. The respirator helps to provide
protection against particulates and to prevent the transmission of disease between people.
The components of the CleanSpace HALO system are shown in Section 7. The respirator draws ambient air through
the high efficiency filter and supplies filtered air to the wearer via the mask. CleanSpace HALO is a breath
responsive respirator which means that it blows harder during inhalation and more softly during exhalation. The
device continuously adjusts fan speed to maintain positive pressure in the mask. Should the filter become blocked,
an audible alarm will sound and the “Filter” light on the keypad will be illuminated. If the battery voltage falls below
the minimum required to sustain the designed flow rate, an audible alarm will sound.
WARNING
Properly selected, used and maintained respirators help to protect against certain airborne
contaminants. It is essential to follow all instructions and government regulations on the use
of this product, including wearing the complete respirator system during all times of
exposure, in order for the product to help protect the wearer. Misuse of respirators may result
in overexposure to contaminants and lead to sickness or death. For proper use, see your
Occupational Health Specialist, these user instructions or contact CleanSpace Technology
Customer Support on sales@cleanspacetechnology.com or the website:
cleanspacetechology.com/welcome/
4. List of Warnings within these User Instructions
This product is part of a system that helps protect against certain airborne contaminants. Misuse may result in sickness or death. For proper use,
see your Occupational Health Specialist, these user instructions or contact CleanSpace Technology Customer Support on
sales@cleanspacetechnology.com or the website: cleanspacetechology.com/welcome/
Properly selected, used and maintained respirators help to protect against certain airborne contaminants. It is essential to follow all instructions and
government regulations on the use of this product, including wearing the complete respirator system during all times of exposure, in order for the
product to help protect the wearer. Misuse of respirators may result in overexposure to contaminants and lead to sickness or death. For proper use,
see your Occupational Health Specialist, these user instructions or contact CleanSpace Technology Customer Support on
sales@cleanspacetechnology.com or the website: cleanspacetechology.com/welcome/
CleanSpace respirators are unsuitable for use in oxygen deficient atmospheres.
If a satisfactory quantitative fit factor or passing qualitative test cannot be achieved with any of the masks, CleanSpace HALO must not be used. A
satisfactory quantitative fit factor is
If a satisfactory Seal Check cannot be achieved, do not enter the contaminated zone.
Be sure to remove the Seal Check Cap before entering the contaminated area. The Cap blocks the exhalation valve, making it more difficult for your
exhaled air to be expelled from the mask. Failure to remove the cap will lead to increased levels of rebreathed Carbon Dioxide, and may result in
headache or dizziness. Never leave the cap in place for more than 2 minutes!
If you cannot adjust the mask to avoid your hairline, the mask is not suitable for you and should not be worn.
Do not remove the respirator until you have vacated the contaminated area. If you have an acute and spontaneous health episode (i.e. experiencing
dizziness) and believe removing the respirator while you leave the contaminated area may help, remove the respirator with caution.
To Next Page
Loading...
