CleanSpace HALO - Product Specifications and Information; Technical Specifications Overview

34
SIGNIFICANCE OF MARKINGS
Marking
Meaning
See information supplied by the manufacturer.
Manufacturers recommended storage conditions - temperature.
Manufacturers recommended storage conditions – humidity.
23. Specifications
Air Flow
Greater than 120 litre/minute.
Breath-responsive, with maximum inflow to mask of 120 – 220 litres per minute,
dependant on filter loading, altitude and battery condition.
Operating Temperature
Range
-10°C to 45°C.
The motor will shut down while the temperature of the battery pack is above 60°C or
below -10°C.
Operating Humidity Range
Zero to 90%, non-condensing.
Operating Altitude Range
Approximately sea level to 3000m.
Charging Temperature
Range
0°C to 35°C.
The battery will not accept charge outside of this range.
Storage Conditions
Short term storage under 30 days: -10°C to 35°C & 30% - 50% RH.
Long term storage (> 30 days):
18°C to 28°C & 30% - 50% RH.
Out of direct sunlight, in a clean, dry environment.
Battery
Lithium Ion Polymer - 1800 mAh
Run Time
On EN12942 Duration Test: 4.5 hours.
Run time is impacted by work rate, mask leak, filter dust loading, altitude and other
factors. Run times may vary widely. Actual use time is likely to range from around 4
hours (heavy work, clogged filter, higher altitude) to around 8 hours (light work, clean
filter, sea level).
IMPORTANT: Short run times (under 4 hours) may be a sign of poor mask fit – seek
advice from a trained safety specialist or CleanSpace Support
at
www.cleanspacehealth.com
Recharge Time
2 hours (to 95%).
Low Battery Voltage Alarm
Triggers when the remaining run time is around 5 to 1
5
minutes.
Audible alarm, 3 beeps, repeated every second, 75dB(A) at ear.
Filter Blocked Alarm
Triggers when the filter loading is high and the filter requires replacement.
Audible alarm: 2 beeps repeated every second, 75dB(A) at ear.
Visual alarm: Red filter LED flashes.