5
6. Limitations of Use
Use this respirator strictly in accordance with all instructions in these user instructions. Never modify or alter this
product.
•
Do not remove the respirator until you have left the contaminated area, unless you have immediate and
sudden health reasons to do so (for example you are experiencing dizziness and believe removing the
respirator while you leave the contaminated area may help).
•
CleanSpace Respirators are tight-fitting and national standards recommend the user be clean shaven. If a
satisfactory fit factor cannot be achieved with any of the masks, CleanSpace respirators must not be used.
•
This respirator with the half mask does not protect your eyes. In conditions that may damage or irritate
eyes, use protective eyewear.
•
Only use your respirator with the approved parts and accessories listed in these user instructions.
•
Do not use the respirator unless it is powered and running normally.
•
Do not use the respirator while it is being charged via the battery charger.
•
Do not use in airborne contaminant concentrations above those specified in your national regulations.
•
Do not use for respiratory protection against unknown atmospheric contaminants or when concentrations
of contaminants are unknown or immediately dangerous to life or health (IDLH).
•
Do not use in oxygen deficient or oxygen enriched atmospheres. Do not use in flammable or explosive
environments.
•
Only for use by trained personnel.
•
Filters need to be changed regularly. The frequency of change depends on use and the concentration of
contaminants in the atmosphere.
•
Do not use for escape purposes. National regulations may impose specific limitations on the use of filters
depending on the filter class and the facemask used.
•
If the respirator has been used in an area that has caused it to become contaminated with a substance
requiring special decontamination procedures it should be placed in a suitable container and sealed until
it can be decontaminated.
•
Do not disassemble the respirator case. There are no user serviceable parts inside.
•
Failure to follow all instructions on the use of this product, and/or failure to use the respirator during times
of exposure, may lead to adverse effects on the wearer’s health and may render the warranty void.
Immediate Evacuation
Leave the contaminated area immediately if any of the following occurs.
•
The respirator warning lights and/or sounds activate for the Low Battery or the Filter Blocked alarms.
•
Any part of the respirator is damaged.
•
Air flow into the mask decreases or stops.
•
Breathing becomes difficult or increased resistance occurs.
•
You feel dizzy or your airway is irritated.
•
You can taste or smell contaminants.
Operating Conditions
Your respirator is suitable for use in the following atmospheric conditions.
•
Temperature:
-10°C to 45°C.
•
Relative humidity:
0 to 90% non-condensing.
The respirator will stop functioning if its internal temperature rises above 60°C or falls below -10°C.
To Next Page
Loading...
