EF-701M INTERFACE 2-1
INSTALLATION
CONNECTING THE EF-701M INTERFACE
CONNECTING THE EF-701M TO A MATRIX PORT
To connect the EF-701M directly to a Clear-Com Matrix frame port:
1. On the EF-701M’s back panel, set mode-switch 1 to the ON position.
The Data LED will remain ON, except when the unit is being nulled.
2.Connect a CAT-3, CAT-5, or above cable from the RJ-45 Matrix connector on the back
panel of the EF-701M to a port (RJ-45) on the Matrix frame.
The EF-701M is powered from the 2-wire intercom line. When the EF-701M is
receiving power, the Matrix will recognize it as a CCI-22 Two-Wire Interface.
3.Program the Matrix port. Refer to the Eclipse Configuration System (ECS) Manual for
instructions.
2
To Next Page
Loading...
