ICS-2003 INTERCOM STATION
1-7
Removing Labels from the Answer-Back Stack
Any label will be automatically removed from the stack if it is not answered
within a certain time interval, which is set by the answer-back auto-clear time in
the configuration program.
To manually remove the current caller’s label from the answer-back stack, push
up on the “Answer Back” selector.
Calling an Unassigned Station
To call a destination in the answer-back stack:
1. Push up on the “Answer Back” selector to highlight the desired label in the
answer-back stack.
2. Once the desired label is highlighted, press the selector down to talk.
Keypad: Single-Function Buttons
The first column of buttons on the keypad consists of:
•“Mic On/Off”
•“Speaker On/Off”
• “Mic Select”
• “Listen Level”
Mic On/Off Button
This button activates the panel or headset microphone, whichever has been
selected. The LED indicates when the microphone is on. If a talk is activated
while the microphone is off, it will turn on for the duration of the call.
Speaker On/Off Button
This button functions only when a headset is plugged into the station. To toggle
the speaker on and off, push the “Speaker On/Off” button. The LED indicates
when the speaker is on.
Mic Select Button
This button selects the panel or headset microphone. If a headset is plugged in,
the station will automatically switch to headset microphone operation. If the
headset is unplugged, the station will automatically switch back to panel
microphone operation. The LED to will be on when the panel microphone is
active.
Listen Level Button
The Listen Level button has four functions:
• Activating the listen-level mode
• Resetting the listen-level settings
• Sending call signals
• Releasing auto-answered telephone lines
To Next Page
Loading...
Need help?
General
