To Next Page

To Previous Page

ICS-2003 INTERCOM STATION

1-8

Listen-Level Mode

To use the listen-level adjust mode:

1. Push (for less than 1 second) and quickly release the “Listen Level” button.

2. “Listen Level Adjust Mode” will appear in the message window to indicate the

function is on and the LEDs of all active listen selectors will begin to flash.

Note: Only active selectors can be adjusted in listen-level mode.

3. Use the selector associated with the intended label to increase (up) or decrease

(down) the volume.

4. To exit, push the “Listen Level” button or wait for the 3 second time-out.

Listen Level Reset

To reset the Listen Level to default settings:

1. Press (for less than 1 second) and quickly release the “Listen Level” button.

2. Press and hold the “Listen Level” button for 3 seconds.

3. Release the “Listen Level” button.

Call Signals

To activate a call signal push and hold (for at least 1 second) the “Listen Level”

button until the station indicates it is in “Call Signal” mode.

The call signal will be sent each time the selector with that label assignment is

pushed down and will remain so until the call-signal mode times out (about 5

seconds).

Call signals can be issued to any talk label assigned to a station’s talk/listen

selectors. If more than one label is assigned to a selector, all labels will receive the

signal. If a label is a fixed group, the entire group will receive the call signal. If the

label is a party line, then every station listening on the party line will receive the

call signal.

Remote Telephone Line Release

This function is available only if specifically enabled in the configuration

program. To hang up a telephone interface left off the hook:

1. Push and hold the “Listen Level” button for at least 1 second to activate the

call-signal mode.

2. While holding the “Listen Level” button, press the talk selector of the desired

telephone’s label.

3. Release the “Listen Level” button.

Note: In addition to hanging up the telephone interface, this will deactivate any

talk/listen selector set to the interface from anywhere in the system.

Clear-Com ICS-2003 User Manual

Questions and Answers: