Clear-Com Communication Systems Page 13 of 16
Tempest 2400 T-Desk Software User Guide
Use “Channel Select A/B” or “Channel Select C/D’ buttons to completely disable any channel. Disabled
channels will be hidden on the BeltStation display.
Use “Stage Button” to enable the STAGE button on the BeltStation and to enable the relay that is
associated with the STAGE button by default.
Under “Volume Limits” adjust the sliders to control the Maximum and Minimum volume for the belt.
The minimum volume should be increased in cases where the BeltStation user needs to always have at
least low level audio in the headset. The maximum volume may be decreased in quiet environments
where audio may escape the headset unintentionally or for user comfort.
The “Call Button” can be enabled or disabled for each user.
“Call Alert” allows selecting how a CALL message will notify the user. Select a tone only or BeltStation
vibration only or both. “Both” is the default.
“Enter ISO” allows enabling or disabling ‘Wireless ISO’ sometimes referred to as ‘wireless-talk-around.’
‘Wireless ISO’ allows communication between wireless only users, bypassing any wired intercom that
may be connected, by pressing the ENTER button in a push-to-talk manner.
“Low Battery” allows enabling or disabling the low battery alert that may be heard in the headset.
Note that the Dashboard Status Bar appears along the bottom of the T-Desk display in the BeltStation
Settings tab just as it does in the BaseStation Settings tab.
To Next Page
Loading...
Need help?
General
