Clearlight Sanctuary 5 - Locating and Plugging in Power Cord; Installation Is Complete

17
www.infraredsauna.com
INSTALLING DOOR HANDLE
15
1. Locate the door handle.
2. This part comes pre-assembled and will need to
be unscrewed before installation
3. Line up the holes on either side of the glass and
aach the door handle using the enclosed screws.
4. Add wooden screw hole covers on top of screws
to plug the holes.
The power cord comes out of the roof of the sauna. If you are standing facing the sauna, it comes out of the rear le
corner of the roof. Open the trap door to access the power cord and run the cord down the back of the sauna. The power
cord will plug into the appropriate electrical receptacle.
LOCATING AND PLUGGING IN POWER CORD
16
Installation is Complete
Installation of your sauna is now complete. Using a damp cloth, wipe out the sauna to remove any excess saw dust that
may have seled on the wall, floor, and heater panels during manufacturing and shipping. Please refer to usage instruc-
tions located later on in this manual.
We do not recommend using an extension cord for your sauna. Please plug the sauna directly
into the wall receptacle.
Be careful not to overtighten the screws.