4
www.infraredsauna.com
Installation
Choosing a location
Place your sauna on a dry and level surface for best
results. Garage, basement, aic, playroom, bedroom, or
garden house are just a few of the possible locations for
your sauna.
Your sauna’s natural Mahogany or Basswood exterior will
beautifully compliment any location.
Outside, place the sauna on a deck or concrete pavers,
available at your local building supply store, to protect it
from moisture in the ground which can wick up through the
wooden feet. Outside installation also requires our optional
canvas cover.
Installation requirements for your sauna are as follows:
1. Your Clearlight sauna is a self-contained and free-
standing unit. It should not be built into any structure
without prior authorization.
2. Please maintain a minimum of 4-inch clearance on all
sides of the unit to allow air to circulate while giving
access for the power cord.
3. We recommend plugging your sauna into a dedicated
circuit to ensure your sauna functions properly and
doesn’t trip the breaker.
Cleaning and Maintenance
Safety Note: Before cleaning, make sure the heaters are o,
the sauna is unplugged, and it has completely cooled down.
1. Initial Cleaning:
A. Before using your sauna for the first time, clean the
inside of the sauna with a damp cloth.
2. Cleaning:
A. Clearlight® infrared saunas provide dry heat and
require minimal cleaning.
B. For a thorough clean, use a non-toxic, no-VOC sauna
cleaning solution or make your own. You can use a few
drops of high-quality essential oil in water or a mixture
of 1 tablespoon of baking soda in a gallon of water for a
deeper clean.
C. Using pure or distilled water helps minimize mineral
buildup and reduces future maintenance needs.
D. Flocked Surfaces on Full Spectrum Heaters: Use a
lint roller or so brush to clean any dust or debris from
the flocked surfaces of the heater.
E. Vents: Use canned air to blow out any dust from the
vent openings, or use a vacuum with a so brush at-
tachment to gently clean the area. Alternatively, a hair
dryer on the cool seing can be used to blow dust out
of hard to reach areas.
3. Exterior Care:
A. Use your favorite non-toxic, no-VOC furniture polish
on the exterior of the sauna to maintain its appearance.
4. Care Tips:
A. Regular cleaning ensures you can enjoy your sauna
for years.
B. Your Clearlight Infrared Sauna is made of Mahogany
or Basswood. If the fresh wood fragrance is strong, wipe
the wood with a damp cloth to minimize the aroma.
C. Perspiration may darken the wood over time. To
restore its appearance, lightly sand aected areas with
fine-grit sandpaper.
Please be careful when carrying and
installing the glass pieces to avoid breakage.
Make certain the glass is securely fastened
during installation before leing go of any
individual piece that could break.
To Next Page
