Clearlight Sanctuary 5 - Placing Floor Panel; Connecting the Back Panel to the Floor Panel

7
www.infraredsauna.com
CONNECTING THE BACK PANEL TO THE FLOOR PANEL
1. Connect the back panel to the floor panel by lining up the back panel on the groove of the floor panel.
2. When moving the walls, li from the boom of the heater grate frame. Do not li from the heater guard slats.
3. Slot the wall panel into the floor panel and line it up with the side-wall molding.
2
PLACING FLOOR PANEL
1. Place the boom floor panel on the ground near the location where you will be using the sauna. Make sure the
front of the floor is in the desired location of the door. The four plugs and the door magnet indicate the front of the
sauna.
2. Be sure to check the floor with a level to make sure it is level. Add shims if necessary. If the floor panel is not level,
the wall panels may not connect evenly aecting final installation.
1