8
www.infraredsauna.com
CONNECTING THE SIDE WALLS
3
The side wall panels will be connected to the back wall
by connecting together the installed brackets. There are
“+” brackets and “-” brackets on the side of each panel.
Please refer to our installation video to see these steps in
action. The side walls will be installed as follows:
1. Place the le side wall in the slot in the floor. Li the
side wall up about 4” (10cm) higher than the back wall
panel (See Picture 1).
2. Place the side wall panel against the back wall (See
Picture 2), then slide down the side wall panel until
3. the two panels are equal height. (See Picture 3).
4. In order to lock the pins from the side wall to the rear
wall, rock both walls back towards you then push the
walls together.
5. If the panels are not equal height or there is an obvi-
ous gap between the two panels, this means they are
not properly aached and you should try again.
6. Repeat the steps above for the right side wall panel.
Le Side Wall Installed
Right Side Wall Installed
Picture 1 Picture 2 Picture 3
If the panels still seem too tight to come down all the way, try backing o the bracket screws by one half
turn with a Phillips head screwdriver.
To Next Page
