Quick-Start Guide
11
CONFIGURE DEVICE SETTINGS
Depending on how you’re connecting to a CONVERGE Pro 2, there
are some device settings you need to configure. If you’re connecting
via Wi-Fi or Ethernet using a static IP address, you must configure the
relevant network settings. Additionally, in order to get the correct time
on call logs, you need to configure some date and time settings. The list
below shows which steps to follow.
• If you’re using Wi-Fi to connect, follow the steps for Configure Wi-Fi
Settings.
• If you plan to use Ethernet with DHCP, no configuration is necessary.
If you’re using Ethernet to connect and you need to set a static IP
address, follow the steps for Configure Ethernet Static IP.
• Follow the steps for Set Date and Time.
NOTE: Be sure you’re using Dialer version 2.0.7.2 or higher. You can check the version
by tapping Settings, About.
Configure Wi-Fi Settings
If you’re planning to connect the Touch Panel Controller to a CONVERGE
Pro 2 via Wi-Fi, you must configure the Touch Panel Controller’s Wi-Fi
settings.
1. Tap
.
2. Tap Network.
The Network screen appears:
To Next Page
Loading...
