TOUCH PANEL CONTROLLER
18
CONNECT TO A CONVERGE PRO 2
Before you can use the Touch Panel Controller to control a CONVERGE
Pro 2, you must make a connection to the CP2:
1. From within the Touch Panel Controller Dialer, tap Settings.
2. Tap Connection.
The Connection screen appears.
3. Tap Add/Edit.
4. Tap New Connection.
The Add Connection screen appears.
5. Tap Connection Info.
The Connection Info screen appears.
6. Type a name for the connection in the Connection Name field.
7. If you are using Wi-Fi or Ethernet for communications, tap Telnet
next to Connection Type. If you’re using a serial cable to connect,
tap Serial, then skip to step 10.
8. Type the IP address or domain name of the CP2 device in the
Telnet IP Address or FQDN field.
9. Enter the Telnet username and password for the CP2 device in the
Telnet Username and Telnet Password fields.
The default username for a CP2 is “clearone” and the default password
is “converge”.
To Next Page
Loading...
