ClearOne CONVERGE PRO 2 - Connect to a CONVERGE Pro 2 (Continued)

Quick-Start Guide
19
10. Choose a phone type (VoIP or Telco) from the Phone Type switch.
11. Select either Telco/VoIP EPN (to specify an end point number) or
Label (to specify a channel label) and then type the appropriate
end point number of label in the relevant field.
12. To automatically connect to a CP2 using these settings each time
the Dialer starts, turn on the Auto Connect on Startup switch.
13. Tap the left arrow icon to return to the Add Connection screen.
14. Tap Volume Up/Down.
The Volume Slider screen appears.
15. To set the volume slider settings automatically, type a channel or
group label in the Use Speaker Group field.
16. Tap the left arrow icon to return to the Add Connection screen.
17. Tap Mute.
The Mute Button screen appears.
18. To set the mute button settings automatically, type a channel or
group label in the Use Microphone Group field.
19. Tap the left arrow icon to return to the Add Connection screen.
20. Tap Save.
21. Tap the link icon next to the connection you just created to connect
to the CP2 device.
NOTE: For more detailed instructions on creating a link to a CP2, see the Touch Panel
Controller for CONVERGE Pro 2 User Manual.