Need help?Do you have a question about the ClearOne CONVERGE PRO 2 and is the answer not in the manual?
Details connecting the Touch Panel Controller to a CP2 using the DB9 RS232 port directly.
Illustrates connecting the Touch Panel Controller to a CONVERGE Pro 2 via Wi-Fi through a network switch and Wi-Fi router.
Explains serial connection through a CP2 GPIO or USB Expander using a Phoenix Euroblock Adapter.
Describes connecting the Touch Panel Controller to a CONVERGE Pro 2 via Ethernet using a CAT5e/CAT6 cable to a PoE-capable switch.
Details connecting the Touch Panel Controller to a CP2 using the DB9 RS232 port directly.
Illustrates connecting the Touch Panel Controller to a CONVERGE Pro 2 via Wi-Fi through a network switch and Wi-Fi router.
Explains serial connection through a CP2 GPIO or USB Expander using a Phoenix Euroblock Adapter.
Describes connecting the Touch Panel Controller to a CONVERGE Pro 2 via Ethernet using a CAT5e/CAT6 cable to a PoE-capable switch.
General| Model | CONVERGE PRO 2 |
|---|---|
| Product Type | Audio Conferencing Processor |
| Manufacturer | ClearOne |
| Connectivity | Ethernet, USB |
| Ethernet Ports | 1 |
| USB Interface | USB 2.0 |
| Sample Rate | 48 kHz |
| Bit Depth | 24-bit |
| Acoustic Echo Cancellation (AEC) | Yes |
| Noise Reduction | Yes |
| Automatic Gain Control (AGC) | Yes |
| Frequency Response | 20 Hz - 20 kHz |
| Power Supply | 100-240VAC, 50/60Hz |
| Operating Temperature | 0°C to 40°C (32°F to 104°F) |
| Humidity | 10% to 90% non-condensing |
| Audio Processing | Digital Signal Processing |
| Line Outputs | 8 |
| AEC Channels | 8 |
| Network Interface | Ethernet |
| Total Harmonic Distortion + Noise (THD+N) | <0.01% |
| Signal-to-Noise Ratio (SNR) | > 90 dB |
| Storage Temperature | -20°C to 70°C |
| Certifications | CE, FCC |
To Next Page
