ClearOne CONVERGE PRO 2 - Configure Ethernet Using Dhcp; Configure Ethernet Using a Static IP

Quick-Start Guide
13
5. Type the password for the selected network in the Password field.
6. If you need to configure a proxy or set a static IP address, check
the Advanced options check box.
7. Configure advanced options as needed.
8. Tap Connect.
Configure Ethernet using DHCP
If you’re planning to connect the Touch Panel Controller to a CONVERGE
Pro 2 via Ethernet using DHCP, no further configuration is required.
Configure Ethernet using a Static IP
To use Ethernet using a static IP address, follow these steps:
1. Tap
.
2. Tap Network.
The Network screen appears.
3. If it’s not already selected, tap Ethernet.
4. If it’s not already selected, tap Static IP Address.
5. Type values for the IP address, Subnet Mask, Gateway Address,
DNS 1, and DNS 2 fields.
6. Tap Apply.