ClearOne CONVERGE PRO 2 - Providing Power; Providing Communications

To Next Page

To Previous Page

Quick-Start Guide

PROVIDING POWER

There are three ways to provide power to the Touch Panel Controller:

• AC Power Adapter attached to the power connector at the bottom

of the device.

• Ethernet connected to an PoE injector or PoE-capable switch via

the RJ45 connector at the bottom of the device.

• Ethernet connected to a P-link-capable ClearOne device via the

RJ45 connector at the bottom of the device.

PROVIDING COMMUNICATIONS

In order for a Touch Panel Controller to work, it must be connected to a

CONVERGE Pro 2 (CP2) device. In order for the telephony-specific Dialer

functions to work, the Touch Panel Controller must be connected to a

CONVERGE Pro 2 device that is either VoIP or Telco capable.

There are four ways to provide communications between the Touch Panel

Controller and a CP2:

Other manuals for ClearOne CONVERGE PRO 2