Clesana C1 - Preparation; First steps; Choose the installation location; Dismantle the existing toilet

15/3214/32
6. 
6.1. First steps
X 
X Have tools and consumables ready.
6.2. Choose the installaon locaon
The Clesana C1 can be installed both with the round base and with the L-Adapter. The


clesana.com/info-area-

A B
Fig. 1: 
 
X Using the measurements of the Clesana C1 ensure the following points on the

– 
its own weight.
– 
– 
6.3. Dismantle the exisng toilet
1. 
-
nector. A plug specially provided for this purpose can be used for a distributor.
2. 
3. Ensure that the shut-down water line does not allow any standing water in the line.
4. 
6.4. Prepare L-Adapter or round base
No. Tools and consumables
1 Screwdriver Torx TX20
1. -

2. 4 × Loosen the screws with screwdriver

discs (1).
1
3. Loosen the exposed cable from the
cable duct of the L-Adapter or the
round base.
4. 
cm and remove from the L-Adapter or
round base.