Clevo N350TW - Removing and Installing a Processor

Disassembly
Removing and Installing a Processor 2 - 11
2.Disassembly
Removing and Installing a Processor
Processor Removal Procedure
1. Turn off the computer, turn it over, and remove the battery (page 2 - 5), component bay cover (page 2 - 6) and
RAM (page 2 - 9).
2. The CPU heat sink will be visible at point (Figure 7a).
3. Remove screws - from the heat sink unit in the order indicated on the label (i.e screw first through to
screw last Figure 7b)
.
4. Carefully (it may be hot) remove the heat sink unit (Figure 7c).
A
1
4
4
1
B
a.
b.
1
2
3
A
c.
4
B
B
Figure 7
Processor Removal
a. The CPU heat sink will
be visible at point .
b. Remove the screws from
the CPU heatsink.
c. Carefully lift the heat
sink up and off the com-
puter.
A

B. Heat Sink
•4 Screws