Clevo N350TW - Page 42

Disassembly
2 - 18 Removing and Installing the M.2 SSD Module
2.Disassembly
M.2 SSD Installation Procedure
1. Place the thermal pad on the mainboard as shown (Figure 13a).
2. Insert the module in the computer
(Figure 13b).
3. Tighten the screw to secure the module in place
(Figure 13c)
1
2
3
b.
c.
a.
3
2
1

Thermal Pad
Make sure to place the thermal pad’s adhesive side down on the
mainboard’s surface as illustrated. Insert the module with the ther-
mal pad facing the mainboard.

1.Thermal Pad
2.M2 SATA Module
•1 Screw
Figure 13
M.2 SSD Module
Installation
a. Place the thermal pad.
b. Insert the module.
c. Tighten the screw.