Clevo NL50MU - Page 31

Disassembly
Removing the Battery 2 - 7
2.Disassembly
48WH Battery Upgrade Process
1. Turn off the computer, turn it over.
2. Remove screws - on the bottom case (Figure 1a).
3. Note to remove screws
- , do so with the screwdriver angled at about 90 degrees to the computer surface
as shown (Figure 1b
).
4. Carefully lift the bottom case up and remove it.
5. The battery will be visible at point on the computer (Figure 1c).
1
12
6
9
13
14

13. Bottom Case
•12 Screws
Figure 3
Battery Removal -
48WH
a. Remove the screws.
b. Remove the bottom case.
c. Locate the battery.
a.
b.
1
2
4
c.
8
5
6
7
3
9
10
11
14
13
12
8
6
7
9
13

Hard Disk
Note that Models using a 48WH battery
will not have a hard disk installed.